|
 |
-To connect the DA100 directly to a PC, use one cross cable.
-To connect the DA100 to a PC via a hub, two straight cables are required. |
| No. DAQ32PLUS only supports one unit at a time. Please consider using DAQLOGGER. |
| Communication cannot take place if the same IP address is set. |
| Ethernet, RS232C, RS422A/RS485, and GPIB. |
| Please use a board by NI (National Instruments). |
| Open the DAQ32PLUS "Software Configurator" icon and check whether ETHERNET is selected in the "communication" tab, and that the IP address of the DA100 is set. If the DA100's IP address is not set, enter the address and restart DAQ32PLUS. |
| After starting up the DAQ32PLUS monitor server, start up the client. |
| Yes. And on the other hand, older clients cannot be used with newer servers. |
| DARWIN instruments shipped on or prior to mid June, 2007 do not support IP address settings on Windows Vista (however normal communications are possible). You can enter settings from Windows 2000/XP, or from the menu on the main unit if using the DC100 or DR series. |
| With the latest release (R11.06 or later), the Windows firewall blocks running of the IP address setting program. We apologize for the inconvenience, but as a workaround you can disable the Windows firewall, or as explained in the appendix to the DAQWORX Installation & Operation Guide, you can add the DAQ32Plus Launcher program to the Windows firewall exceptions. |
| Yes, you can use the auto processor. |
If no settings were changed, check the following.
- Check the free hard disk space and check for disk errors
- Check the power to the DA100 and the green STATUS lamp
- Check the connection of the communication cables and replace if necessary
|
| The exclamation point appears when data cannot be written to the hard disk.
Check whether the destination folder exists, and whether there is sufficient free space on the hard disk. |
| The time displayed on trends is that of the DA100. When connected for long periods, the time on the PC and DA100 can diverge. If you disconnect and reconnect the instruments the time on the DA100 is automatically set to that of the PC. |
| Use the DAQ32PLUS client package. With the most recent version, a single DAQ32PLUS monitor server can support up to sixteen clients. |
| One group contains up to 32 channels, and up to 30 groups can be created.
The display span can be set in the display settings. |
| For DAQ32PLUS, it is up to 1800 data. |
| Upload the settings by choosing the DARWIN Hardware Configurator icon > Comm. > Receive.
Next, choose Comm. > Action > Strain Bal./Init., using Type of Initial Balance and Object Input Channels of target channels. (Type of "Initialization" restores the values entered upon shipment from the factory.） |
| Yes, the latest version supports it. |
| The latest version (R11.06 or later) supports the Windows Vista Home Premium 32-bit, and Windows Vista Business 32-bit versions. |
| A release upgrade kit for DAQ32PLUS is available. |
|
|
|
|
| If you can not find your answers here, please feel free to contact us. |
|
|
|
|
|
