With DL9000 Series MSO Models, you not only have access to the existing DL9000 series of powerful trigger functions, but you can also set trigger conditions using a logic signal as the source.
You can restrict capture to the desired signals by combining various trigger conditions, thus reducing evaluation times and speeding up troubleshooting.


DL9000 Series MSO Models' Trigger Functions



Examples of Trigger Application

• Trigger-based gating - Edge (Qualified): conditional trigger -
  The valid/invalid state of an edge trigger or pulse width trigger can be controlled according to the conditions of any other channel’s state (high/low).
  
  
  
  
• Setup time trigger / Hold time trigger
  To derive setup time/hold time conditions, event delay/event sequence triggers are set as shown in the following figure.
  
  

DL9000 Series MSO Models allow you to assign 32-bit logic signals to up to five groups.
There is no limit to the number of bits allowed in each group. For example, you can assign all 32 bits to a single group.
Groups are assigned using a graphical interface for flexible and easy settings.
For example, even in cases such as where a reconfigurable device's pin assignments have been changed, you can make the corresponding adjustments simply by changing the mapping of the groups.
Analysis such as bus display, state display, and DA conversion can be executed on a group-by-group basis.

Product Home

Specifications

Features

Software