|
| Logic Probes and Accessories |
The DL7400 series lets you measure analog (4 CH or 8 CH) and logic(16-bit) signals simultaneously in one unit.
The DL750 lets you capture up to 16 analog channels and 16-bit logic signals simultaneously. The following logic
probes are used with these instruments.
|
 |
 |
701980 Logic Probe for the DL7440/DL7480 |
Input impedance: 1 Mohm/10 pF
Max. toggle frequency: 100 MHz
Max. operating input voltage: ±40 V
Threshold level: ±40 V (0.1 V resolution)
Min. pulse width: 5 ns
|
|
 |
|
701981 Logic Probe for the DL7440/DL7480 |
Input impedance: 10 kohm/9 pF
Max. toggle frequency: 250 MHz
Input voltage range: ± 10 V
Threshold level: ±10 V (0.1 V resolution)
Min. pulse width: 2 ns |
|
 |
|
700986 Logic probe for the DL750 - non-isolated inputs |
Two measurement leads (B9879PX and B9879KX) included. |
|
 |
|
700987 Logic Probe for the DL750 - isolated inputs |
Use with measurement lead 758917 and 758922, 758929 or 701954
adapter leads (below). 701954 is shown on page 8. |
|
 |
|
758917 Measurement lead set |
A set of 0.8m long red and black test leads, used in combination
with a pair of optional 758922 or 758929 alligator-clip adapters. |
|
 |
|
758922 Small Alligator-clip Adapter |
Rated at 300 V. Attaches to the 758917 test leads. Sold in pairs. |
|
 |
|
758929 Large Alligator-clip Adapter |
Rated at 300 V. Attaches to the 758917 test leads. Sold in pairs. |
|
 |
|
B9852ES IC Clip |
Attached to the tips of logic probe (701980 or 701981) or mini-clips
(B9852CR), the IC clips can be used to clip contiguous 0.5-mm pitch
terminals. A total of 10 clips are included. |
|
|
|
Another probes and Accessories |
|
|
|
| · |
Probes for Digital Oscilloscopes |
|
|
|
|
DL Series Selection Guide
Find the right one for you! |
Serial Bus Analyzer Selection Guide
For I2C, CAN, and SPI analysis |
Probes for Digital Oscilloscopes
Supporting a variety of measurement |
Accessories for DL series
Accessories other than probes |
|
|
|
|
|
