An option is available to provide high output (20 mW). In addition, the AQ2200-111 provides a high SMSR value of 45 dB (typical), making it an ideal light multi-wavelength light source for WDM system test.

The AQ2200-111's optical output port consists of an angled PC connector, and it contains an internal isolator to suppress reflective light. This design provides excellent level stability of ±0.005 dB over a 15-minute period.

Optical output can be adjusted in the range of 0 to 10 dB (in steps of 0.01 dB) while maintaining a fixed wavelength. Levels can be adjusted between WDM signal channels.

The DFB laser's spectral width can be set to WIDE or NARROW. During loss measurements, the WIDE setting suppresses interference and makes it easier to obtain accurate measurements.

Wavelength stability of ±0.005 nm or less over a 15-minutes period is achieved using temperature control. The wavelength can be adjusted in a 1.6-nm range.

• Light source for measuring optical fiber amplifiers (EDFA)
• Light source for evaluating B-PON systems at 1310 nm, 1490 nm, and 1550 nm
• Stable light source for PDL measurements
• Light source for modulation (LN modulator) during BERT

AQ2200-111 DFB-LD module

Item			Product specifications
Wavelength specified range			1310 nm, 1490 nm	1524.111 to 1620.555 nm
	Wavelength accuracy		±0.05 nm or less	±0.02 nm or less
Wavelength setting resolution			0.001 nm
Spectral width		NARROW	5 MHz (typical)
		WIDE	100 MHz (typical)
Optical output level			+10 dBm or higher
SMSR			30 dB or higher	45 dB (typical)
Optical level stability		15 minutes	±0.005 dB or less
		24 hours	±0.03 dB or less
Optical attenuation width			10 dB (0.01 dB)
Wavelength stability		15 minutes	±0.005 dB or less
		24 hours	±0.01 nm or less
Wavelength adjustment width			1.6 nm or higher
RIN			-145 dB/Hz (typical)
Internal modulation function			270 Hz, 1 kHz, 2kHz

Product Home

Specifications

Frames