Store the measured data in built-in memory or IC card memory. When an IC memory card is installed, the measured data is stored in the IC memory card.
The STORE function has three operations depending on measurement modes as follows:

• In AUTO mode:
  In AUTO mode, press the STORE key to store data in memory. If the memory overflows, the oldest data are automatically erased and replaced by the newest data. If the STORE mode is OFF, data is no longer stored. In AUTO mode, if a trigger signal is generated, data can be written to the memory, leaving NS 1 data before generating a trigger signal.
• In SINGLE mode:
  In SINGLE mode, data measured in each sampling cycle are stored every time a trigger signal is generated. If NS data that was present are stored, STORE mode is automatically turned OFF.
• In N RDGS mode:
  NS data are stored every time a trigger signal is generated. The STORE mode is in halt status until the next trigger signal is generated. If the memory overflows, the STORE mode is automatically turned OFF.

Recalls the stored data from the memory. The recall functions are as follows:

• In AUTO mode:
  Data are output at the preset measurement intervals. When the final data are output, the recall mode is automatically turned OFF.
• In SINGLE mode:
  Data are recalled every time a trigger signal is generated. When the final data are output, the recall mode is automatically turned OFF.
• In N RDGS mode:
  NS data are output at the preset measurement intervals whenever a trigger signal is generated. Then the mode is in the halt state. If the trigger key is pressed again, recalling of data is started. If the final data are output, the recall mode is automatically turned OFF.

The 7563 is the first Digital Thermometer with IC memory card (optional).
IC memory card allows you to:

• Save up to 8,000 measured data.
• Save functions, ranges, and mathematical functions ON/OFF, sample speed and so on.
• Store setting programs using the front panel keys and measured data.
• Automatic loading at power ON.
  7563 is allowed more applications by the above memory card functions.
  The data format of memory card is compatible with that of YOKOGAWA LR Series Recorders, so the measured data can be recorded in analog form on strip chart.

IC memory cards allow measurement parameters and conditions to be set without using the panel keys. If an IC memory card containing set data is inserted and then the power is turned ON, the memory contents are automatically read and programmings are set.
This is very useful for measurements that are repeated under the same conditions, and this can be a powerful support tool such as in the production line.

If an IC memory card is installed, up to 20 steps can be programmed either by front panel key operations or via communication interfaces.
The required functions, ranges, and mathematical functions can be set ON or OFF, and multichannel measurements can be performed in a combination with scanners.

The AZ key turns ON or OFF AUTO ZERO. AUTO ZERO (AZ) compensates for zero drift which will be generated in the internal circuit every time sampling is executed. In high speed sampling mode, measurement time is decreased by eliminating AUTO ZERO functions.

The multimeters can be calibrated either by front panel key operations or via communication interfaces. The multi-meters are calibrated without opening the case and without any special calibration skills.

This optional feature specifies any data of 3-1/2 or 3 digits on the display and converts it to the analog data with the range of 00 mV or V.
This function is ideal for both long-time temperature measurement and small change of measurement.

By using a programmable scanner 750101 the multi-point measurement of up to 50 points is possible.