GP-IB Interface to prevent electric shock, turn the power to the instrument OFF when connecting it to the PC. Connect a GP-IB cable from the GP-IB connector on the rear panel of the WT series instrument to the corresponding connector on the PC.
- Setting the Address
Set the GP-IB address according to the procedure given in the user's manual that came with the WT series instrument. For details about the GP-IB interface, refer to the information about the communications functions included in the user's manual.
- RS-232C Interface
To prevent electric shock, turn the power to the PC OFF when connecting the instrument to it. Connect an RS-232 cable from the RS-232 connector on the rear panel of the WT series instrument to the serial port of the PC.
- Parameter settings
Follow the procedure given in the user's manual of the WT series instrument to enter the following parameter settings. (Normally, operation can begin using the factory default settings.)
Handshaking: select a method from 0 to 7.
Data format: select a format from 0 to 3.
Baud rate: select 75, 150, 300, 600, 1200, 2400, 4800, or 9600.
Terminator: select CR+LF, CR, or LF.
For details about the RS-232 interface, refer to the user's manual that came with the WT series instrument.
|
