Introduction
Two-way Communication Feature of FOUNDATION fieldbus™ Reduce Total Cost of Ownership
FOUNDATION fieldbus technology enables all-digital, two-way communications between field devices and control systems. While the advantages of using digital communications for sharing maintenance-related device information with an asset management system are well known, there are other benefits from using the FOUNDATION fieldbus technology. This paper introduces an application that relies on the two-way communications capability of FOUNDATION fieldbus.
Expected Benefits
Reduced total cost of ownership (TCO) by eliminating the need for local display panels.
Application
As shown in figure 1, gas flow is calculated by a remote terminal unit (RTU) using process data received from a transmitter. Although such data can be monitored on a SCADA system, a display panel is required to monitor the gas flow on-site.
Fig.1 System configuration using 4-20mA
What is 4-20mA? 4-20mA is an analog signal that has been used as a process signal for decades. It is limited to sending process data. |
Solution
With conventional 4-20 mA communications, it is impossible to send the data calculated by an RTU back to a transmitter because this technology only supports one-way communications. However, as shown in figure 2, gas flow data calculated by an RTU can be sent back to a transmitter using the two-way communications capability of FOUNDATIONfieldbus. The gas flow data can thus be displayed on the transmitter's LCD, eliminating the need for the use of a local display panel or hand-held terminal.
Fig.2 System configuration using FOUNDATION fieldbus
Process data measured by transmitter (INDEX 1-3), output data calculated on RTU (INDEX 4-6) and configuration parameters set to RTU (INDEX 7-10) are periodically displayed on transmitter's LCD with measurement units and comments.
What is FOUNDATION fieldbus? FOUNDATION fieldbus provides all-digital communication. It provides two way communications between devices and their information in addition to process data. |
Customer Site
The United States Department of the Interior Bureau of Land Management (BLM) published a notice of the minimum standards and requirements for the sale and allocation Electronic Flow Computers (EFCs) in 2008. The requirements for EFC displays are mentioned in this notice. "The display shall be readable on site without the need for data collection units, laptop computers or any special equipment, shall be onsite, and shall be in a location that is accessible to the BLM."
To meet these requirements, Yokogawa Corporation of America proposed using the transmitters' LCD as a substitute for local display panels, reducing the total cost of the ownership (TCO) of the projects.
Related Products & Solutions
-
EJX910A
This transmitter precisely measures differential pressure, static pressure, and process temperature; then uses these values in a high-perfomance on-board flow computer to deliver fully compensated Mass Flow.
-
EJX930A
Designed specifically for high static pressure applications, this transmitter precisely measures differential pressure, static pressure, and process temperature; then uses these values in a high-perfomance on-board flow computer to deliver fully compensated Mass Flow.
-
FCJ All-in-one PLC/RTU
The brick type model FCJ autonomous controller fulfills the basic requirements of the utility control. It also provides the reliability for the SCADA communication with network redundant capability.
-
Pressure Transmitters
The accurate and stable measurement of process pressure with Yokogawa Pressure Transmitters supports the safe, reliable, and profitable operation of your plant.
-
Process Control PLC/RTU
From process plants to remote locations, our process control PLC and Remote Terminal Unit (RTU) help users maximize operational excellence.
-
Programmable Logic Controllers
Yokogawa’s PLC products feature ultra-high speed, stable control and high-performance networking for real time, deterministic automation and monitoring.