YFGW410现场无线管理站

YFGW410现场无线管理站以国际自动化协会(ISA)的工业自动化无线通信标准ISA100.11a为基准。该产品具有符合ISA100.11a标准的系统管理/安全管理/网关功能,与现场无线接入点(YFGW510)和/或现场无线媒体转换器(YFGW610)组合,构成现场无线系统。

  • 高度的可靠性和灵活性

    采用分离型结构,通过连接两台本产品实现冗余配置。运行中的现场无线系统无需停车,即可在线进行维护,运行高度灵活。

  • 高度安全的通信

    该产品支持访问控制列表(IP过滤器和端口过滤器)。根据不同角色的设置的密码可以保护用户界面的安全,防止恶意访问。符合ISA100.11a标准的端到端通信使用AES 128位进行加密。通过Achilles 1级认证,通信和安全的稳定性得到了验证。

  • 多协议通道

    该产品兼容如HART和Modbus的外部协议,并在设备和主机系统之间传输。 通过在安全仪表系统(SIS)和无线安全设备之间传输PROFIsafe等安全通信协议,实现整个安全系统所需的安全完整性等级(SIL)。

  • 无线资源的高效利用

    该产品可以灵活利用现场无线网络的带宽,实现可靠、高效的无线通信。 Duocast功能可以与连接到此产品的两个主干路由器(BBR)同时接收数据。内置的数据缓存功能可以节省现场无线网络的带宽和现场无线设备的能耗。

通信接口 标准 100Base-TX2
传输速度 100Mbps
接头 RJ-45
电缆类型 类别5
最大长度 100m
端口数 4个端口
端口名称 B1、B2、B3、B4
保护 Surge
通信协议 Modbus
OPC1
管理/配置等 HTTP
IEEE1588PTP v2
横河专用3
  1. 使用OPC接口连接时,需要现场无线设备OPC服务器(SSS7100)。有关该产品的详细信息,请参阅相关产品的一般规格书(GS)。
  2. 在室外接线至现场网络或现场无线主干网100BASE-TX时,使用非金属拉力构件的光纤连接YFGW610。
  3. 以TCP为基础的定制协议用于本产品与“现场无线OPC服务器”、“FieldMate通用设备管理工具”、“工厂资源管理系统(PRM)”和YFGW510之间的通信。有关各产品的详细信息,请参阅相关产品的一般规格书(GS)。
  4. 维护/诊断网络(100BASE-TX、RS-232C)不能用于室外接线。
  5. 这些仅为横河电机维护用的串行端口。
通信接口 标准 100Base-TX4 RS-232C4 5
传输速度 100Mbps 115.2kbps
Connector RJ-45 RJ-11
Cable Type 类别5 横河专用
Maximum 100m 15m
Number of Ports 1个端口 1个端口
Port Name M1
保护
通信协议 Modbus
OPC1
管理/配置等 HTTP横河专用3
  1. 使用OPC接口连接时,需要现场无线设备OPC服务器(SSS7100)。有关该产品的详细信息,请参阅相关产品的一般规格书(GS)。
  2. 在室外接线至现场网络或现场无线主干网100BASE-TX时,使用非金属拉力构件的光纤连接YFGW610。
  3. TCP为基础的定制协议用于本产品与“现场无线OPC服务器”、“FieldMate通用设备管理工具”、“工厂资源管理系统(PRM)”和YFGW510之间的通信。有关各产品的详细信息,请参阅相关产品的一般规格书(GS)。
  4. 维护/诊断网络(100BASE-TX、RS-232C)不能用于室外接线。
  5. 这些仅为横河电机维护用的串行端口。

 


 

功能规格 温度范围 运行时:-40 to +65°C(海拔高度:最高2000米)
-40 to +55°C (海拔高度:高于2000米,最高3000米)
存储时: -40 to +85°C
湿度范围 运行时:5 to 95 %RH (无结露)
存储时:5 to 95 %RH (无结露)
温度变化率 运行时:±10°C/h
存储时:±20°C/h 
电源 电压范围:10.8~26.4 V DC
额定电源: 24 V DC
瞬时断电: 瞬时断开连接
直流电源波速比:≤1%p-p 
功耗 最大10 W
保护等级 IP20
抗振性 0.15 mm P-P (5~58 Hz), 1 G (58~150 Hz)
耐冲击性 15 G 11 ms
抗干扰性 电场:≤3 V/m (80MHz~1GHz)
静电放电:≤ 4 kV(接触放电)、 8 kV(空气放电)
接地 D级接地(不要与其他仪表共用接地线)
冷却方式 自然空气冷却
强制合规性声明

CE一致性

EMC: EN61326-1 Class A, Table 2, EN55011 Class A group1, EN61000-6-2
安全要求 CSA C22.2 No. 61010-1 (仅用于室内)
防爆类型 ATEX认证n类声明
Co通信接口rface 标准 100BASE-TX2 RS-4853
传输速度

100Mbps
自适应)

38400, 19200, 9600 bps

接头 RJ-45 横河专用
电缆类型 类别5 AWG24~12
最大长度 100m 1200m
端口数 3个端口 1个端口
端口名称 F1、F2、F3
保护 浪涌 绝缘、浪涌保护
Co通信协议tocol

I/O数据和状态

Modbus/TCP
OPC 1 3
横河专用

Modbus/RTU

管理/配置等

HTTP
NTP/SNTP
横河专用3

  1. 使用OPC接口连接时,需要现场无线设备OPC服务器(SSS7100)。有关该产品的详细信息,请参阅相关产品的一般规格书(GS)。
  2. 在室外接线至现场网络或现场无线主干网100BASE-TX时,使用非金属拉力构件的光纤连接YFGW610。
  3. 以TCP为基础的定制协议用于本产品与“现场无线OPC服务器”、“FieldMate通用设备管理工具”、“工厂资源管理系统(PRM)”和YFGW510之间的通信。有关各产品的详细信息,请参阅相关产品的一般规格书(GS)。
概述:
  • Temperature monitoring is required to prevent wind-fueled fire hazards.
  • The measuring points are up to 600 meters away from the control room.
概述:

One important risk to manage with regard to coal stacks is preventing fires due to spontaneous combustion.

行业:
概述:

A battery room is used to storage batteries for emergency power management in the plant. Each substation has battery room and the storage batteries are lead-acid batteries which must be maintained within specified operating temperature limits. Temperature management is important to ensure a long service life of the batteries especially for the plant in desert climates.

概述:

Delayed Coker is a type of coker who's process consists of heating residual oil feed to its thermal cracking temperature in a furnace. The most important variable in industrial furnace control is temperature. Temperature is measured throughout the furnace in different zones and temperature effects the materials being manufactured and therefore must be precisely monitored to prevent deviations in quality of the final product.

概述:

Blending plays a key role in industries such as food, healthcare and chemicals etc. Temperature and vacuum measurements are very important in minimizing the moisture content to ensure the quality of the final product. Strictly maintaining them throughout the process ensures the final product yield.

行业:
概述:

An induction furnace melts metal by creating very large currents in the material. These currents are induced using three electrodes positioned inside the furnace. The furnace is automated so that once the material has been melted, the electrodes are removed and the furnace then tips the molten metal into a crucible where it can be easily transferred to the production line where it will be cast into ingots. The atmosphere is extremely aggressive and the wired infrastructure is both expensive and very unreliable to maintain. The furnace control requires a total of 20 measurement points distributed around and inside the furnace. The harmonic field effects caused by short circuit 40,000 A (300V). The causes significant interference.

行业:
概述:

The client wanted to monitor the pressure of the gas well at offshore platform remotely to reduce maintenance cost and increase safety of maintenance personnel.

概述:

Customer needed efficiency improvement of steel manufacturing by temperature monitoring for heat/cooling equipment. Previous system required periodic compensation lead changing.

行业:
概述:

The client wanted to monitor the temperature on a chimney. Exhaust air is exposed to the heat on the way traveling from the inlet to the outlet in the chimney. Then constituent of the air transform to harmless elements. It is important to keep the temperature in the chimney as designed.

概述:

Direct Reduction Iron (DRI) is one of the processes to reduce oxygen from iron oxide pellets for steel plant. More than 90% of DRI processes use heated LNG as process gas where PID control for temperature or interlock control is of vital importance.

行业:
概述:

Pressure measurement of tubeless tyres to monitor the air loss is one of the key performance tests in the tyre manufacturing units. Relocation of tyres from one testing rack to the other for various tests and frequent movement of the testing setup for conditional tests to various locations calls for cable free implementation for ease of handling.

行业:
概述:

 Ground water well level monitoring is needed.

行业:
概述:
  • Temperature monitoring at a tank farm
  • Temperature and pressure monitoring in tank jungles, three vertical monitoring points.
行业:
概述:

Wireless technology has a long history, and it began around the time that James C. Maxwell theoretically predicted and then proved the existence of electromagnetic waves in the 1860s, and when Heinrich R. Hertz experimentally confirmed the actual existence of the electromagnetic wave in 1888.

概述:

In plant sites, there are various places such as those affording an unobstructed view like tank yards, and others surrounded by metal pipes and equipment obstructing the view (hereafter referred to "pipe jungles"), often seen in oil refinery and chemical on-site plants. The frequency band of radio waves used for field wireless communication is 2.4 GHz, which has high straightness and its ability to go around things can hardly be expected.

横河技报
概述:

The introduction of wireless technologies into plants is anticipated as one of the measures for implementing field digital solutions not only to reduce cable wiring costs but also to improve plant wide safety/stable operations, operating efficiency, and so on.

横河技报
概述:

The FieldMate versatile device management wizard is PC software mainly used for configuring and adjusting field devices. Under the concept of "one tool for all," Yokogawa has been enhancing this software to support a wide range of field devices and field communication protocols.

行业:
概述:

In recent years, expectations for control systems using wireless communications have been increasing in the process control market. This is because these systems do not require power and communication wiring for field instruments, enabling reduced initial and maintenance costs, and easy installation.

想要了解更多的信息,技术&解决方案?


联系我们
置顶
WeChat QR Code
横河电机(中国)有限公司
WeChat Recruiting QR Code
横河电机中国招聘