Process Liquid Analyzer Sensor Wiring Guide

The Liquid Sensor Wiring Guide makes finding the correct wiring for Yokogawa supported liquid analytical sensors simple. To use the guide, follow this 3-step process to find your sensor wiring:

  1. Select your measurement
  2. Select your sensor

No more wasted time flipping through instruction manuals. 

 

Sensor Wiring Guide

Prodotti e Soluzioni Correlati

  • Hot-Tap Holder PR10

    On-line measurements often present extra challenges, especially when routine maintenance is required. The PR10 is ideally suitable for applications where the sensors must be removed without interrupting or shutting down the process. Without any special tools the PR10 can be retracted safely from the process at pressures up to 5 bar (72 psi). Using the PR10 allows us to place any dissolved oxygen sensor that has a PG13.5 connenction into a retractable assembly.

    Vedi di più
  • Conductivity Analyzers

    Conductivity meters, analyzers and transmitters are used for continuous process measurement and monitoring of conductivity, resistivity, WIFI, demineralizer water, RO water, percent concentration, boiler blowdown and TDS.

    Vedi di più
  • Conductivity Sensors

    Conductivity sensors and electrodes are used to measure process conductivity, resistivity, WIFI, demineralizer water, RO water, percent concentration, boiler blowdown and TDS. Various installation options including retractable, flow thru, immersion, and direct insertion. Proper electrode/sensor selection is critical for optimal measurement results.

    Vedi di più
  • Dissolved Oxygen Analyzers

    Dissolved Oxygen (DO) meters, analyzers and transmitters are used for continuous process measurement and monitoring of milligrams per liter (mg/l),parts per million (ppm), parts per billion (ppb), or % saturation. 

    Vedi di più
  • Dissolved Oxygen Sensors

    Dissolved Oxygen (DO) electrodes and sensors are the sensing portions of a DO measurement. There are three common technologies for dissolved oxygen measurements: polographic, galvanic and optical. Various installation options including floating ball, retractable, flow thru, immersion, and direct insertion. 

    Vedi di più
  • pH and ORP Analyzers

    pH and ORP meters, analyzers and transmitters are used for continuous process monitoring of pH and ORP to ensure water/product quality, monitor effluent discharge, batch neutralization, pulp stock, scrubbers, cooling towers, chemical, water/wastewater treatment and many other applications.

    Vedi di più
  • pH and ORP Sensors

    pH electrodes and sensors are the sensing portions of a pH measurement. Various installation options including retractable, flow thru, immersion, and direct insertion. Proper pH electrode/sensor selection is critical for optimal measurement results.

    Vedi di più

Top