|
| Features (1) | Features (2)
DualCapture: A Powerful Tool for Durability Test Data Analysis | Features (3)
Modules | Features (4)
701280 Frequency Module (2 CH) | Features (5)
701280 Frequency Module (2 CH) | Features (5)
701275 Acceleration/Voltage Module | Features (5)
Firmware | Features (6)
Web Services | Features (7)
DC12 V Power Supply Input Option |
|
|
|
* AC and DC power supplies can be used together to ensure a highly reliable power source. An extemal DC source such as a car battery is used for the DC power supply.
|
|
Adding this option enables the DL750 to be run under DC power (10-18 V) as well as AC power (100-120 V/200-240 V). This allows the instrument to be used not only for in-vehicle measurements, but also in a wide range of other testing locations. The power source is switched automatically (when AC and DC are used simultaneously, AC is given priority).
|
The DC Power Box is only 20 millimeters wide1, and weighs 800 grams.
The Power Box fits compactly on the rear panel.2
 |
 |
DC Power Box fits compactly on the rear panel (fits within the height of the feet of the DL1)
|
The DL can still be placed on its back with the option installed. |
|
|
A Power Supply Backup System for Long Duration Observations
|
| Simultaneous input of AC and DC power prevents loss of data when making observations over long periods of time (requires an external DC source such as a car battery). The DC input can be used as a backup power supply. If the AC power goes down, the DL instantly switches to DC input without interrupting the measurement.
|
This option provides lower power consumption than when using an external DC/AC converter. This results in higher efficiency and significantly lower power consumption.
- Approximately 60 VA (typical value for 8 CH/10 MS/s)3
- Approximately 80 VA (typical value for 16 CH/10 MS/s)3
|
Emission noise is greatly reduced compared with using an external DC/AC converter. High voltage switching noise is no longer a problem.
|
|
Two Cable and Connector Options
|
| |
|
|
Low profile DC power
supply connector
(D-sub, 3 pin)
|
|
|
- 701970 DC Power Supply Cable (cigarette lighter plug type)
- 701971 DC Power Supply Cable (alligator clip type)
- B8023WZ DC Power Supply Connector (D-sub 3 pin/solder type)4
1. Not including protrusions (rubber feet).
2. This is a factory-installed option.
3. When printer not in use. When at maximum use, 120 VA (16 CH, 10 MS/s).
4. One DC power supply connector comes standard with the DC Power Supply Input Option.
|
|
|
|
|
DL Series Selection Guide
Find the right one for you! |
Serial Bus Analyzer Selection Guide
For I2C, CAN, and SPI analysis |
Probes for Digital Oscilloscopes
Supporting a variety of measurement |
Accessories for DL series
Accessories other than probes |
|
|
|
|
|
