With increases in the speed of measured signals in recent years, it has become necessary to make floating measurements over a wide frequency band. The 700924 differential probe lets you make wide-band (100 MHz) differential input measurements by just connecting the probe to the input of a single-end input digital oscilloscope.

Accurately observe high-speed differential signals

This probe can be used in combination with the DL9000 or SB5000 series.
Bandwidth: DC to 2.0 GHz (-3 dB)
Input Resistance: 50 kΩ
                        (against GND level from each input terminal)
Input Capacitance: approx. 1.1 pF
                        (against GND level from each input terminal)
Max. operational input voltage: ±7 V
Max. differential input voltage: ±5 V
Attenuation: 1/10

This probe can be used in combination with the DL9000 or SB5000 series.

Bandwidth: DC to 1.0 GHz (-3 dB)
Input Resistance: 1 MΩ
                        (against GND level from each input terminal)
Input Capacitance: approx. 1.1 pF
                        (against GND level from each input terminal)
Max. operational input voltage: ±35 V
Max. differential input voltage: ±25 V
Attenuation: 1/50

Bandwidth: DC to 15 MHz (-3 dB)

Input attenuation ratio: switch between 1/10, 1/100
Maximum allowed differential voltage:
  ±500V (DC+ACpeak) or 350 Vrms (1/100)
Maximum common mode input voltage:
  ±500V (DC+ACpeak) or 350 Vrms (1/10, 1/100)

Bandwidth: DC to 100 MHz (-3 dB)
Input attenuation ratio: switch between 1/10 and 1/100
Maximum allowed differential voltage:
  ±700 V (DC+ACpeak, 1/100)
Maximum common mode input voltage:
  ±700 V (DC+ACpeak) (1/10, 1/100)

Bandwidth: DC to 200 MHz (-3 dB)
Input attenuation ratio: 1/10 (fixed)
Maximum allowed differential voltage: ±20 V (DC+ACpeak)
Maximum common mode input voltage: ±60 V (DC+ACpeak)
50 Ω output

The B9852MJ cable supplies power to the 700924, 700925 and 701921 differential probes* from the DL probe power con-nectors. (The probe power option is re-quired on the DL unit.)

* Cable only works with newer 700924, 700925 and 701921 probes that indicate "6VDC or 9VDC"at the probe input power connector.

Used to connect an oscilloscope hav-ing a 1M-ohm input to a probe with a 50-ohm output. It is required when us-ing the 701920 and 701922 probes with the DL1600 series.

Current Probes | Passive Probes |
Logic Probes and Accessories | Active Probes