SE Asia SG   
On a program controller, can I do contact output when an operation parameter ends?

On a program controller, can I do contact output when an operation parameter ends?

ALn.SSet ALn function selection (within the ALM setup parameter) to a pattern end signal (where n is 1, 2, 3).
Pattern end signal (1 sec):4265
Pattern end signal (3 sec):4266
Pattern end signal (5 sec):4267
* Time in parens. () is ON time

Related Products & Solutions

  • UP35A/UP32A

    The UP35A is a program controller with available 4 patterns and 40 segments (max.) and multi-channel contact I/O. It also includes a ladder sequence function. The UP32A is a compact program controller with up to 4 patterns and 40 segments available. It also includes a ladder sequence function.

    See More

  • UP55A

    The UP55A is a newly-released 1/4 DIN sized program controller provides up to 30 program patterns, and simultaneous monitoring of 8 PV events, 16 time events, and 8 alarms. Also a ladder sequence function is included as standard.

    See More
Top