Level Measurement of Open CIP Chemical Tank


  • At food, beverage and pharmaceutical production lines, tanks and pipes are cleaned and sterilized every time when production is completed.
  • An open tank (Height: 2 to 4 m), open to atmosphere, is used as a chemical tank containing CIP cleaning solution. (CIP: “Clean-in-Place”).
  • Tank level is measured by pressure, but it is sometimes unstable to measure due to small gauge pressure from the tank with sanitary fittings.
Air Supply Measurement for Reactors - Plant image



  • Pressure sensor with suitable measuring range for low pressure measurements. Among the pressure sensors with fill fluid liquid, there are limited options.
  • A pressure sensor without fill fluid can withstand steam and high water pressure with rapidly changing temperature, up to 150 deg C, during cleaning process.
  • Reliable and accurate performance under harsh process conditions with high noise levels.



Precise measurement of liquid level can be expected with EJAC60E,YOKOGAWA’s Fluidless-type Sanitary Pressure Transmitter, that performs reliably and accurately from minimum 20 kPa on small open tanks.

EJAC60E Fluidless-type Sanitary Pressure Transmitter


Features of EJAC60E (= EJA560E + C10SA adapter)

  • Fluidless transmitter has no risk of process contamination with fill fluid.
  • The sensor has a robust diaphragm design for 25 MPa (3600 psi) burst pressure.
  • Transmitter performs steady even for small pressure range (example : 20 kPa, 2.9 psi).
  • Sensor is suitable for high temperature steam cleaning and continuous process temperature up to 150degC (302degF).

EJAC60E input-output test data

Input-output test data:
Max span of EJA560E A capsule : 400 kPa.
Set range : 0 to 20 kPa (Span 20 kPa)
Catalog spec of Accuracy for this range : 0.75 %
Three A capsule units were tested after the range was set for 0 to 20 kPa. The output signal shows much better accuracy than the catalog spec.

  • Sanitary seal multi-adapter (C10SA) for a wide range of connections is offered.
    • ISO Clamp (IDF1S, 1.5 S, 2 S, 2.5 S, 3 S, 4 S)
    • Union (ISO 38, 51, DIN 25, 40, 50)
    • Inline (DN 25, 50, 80,100), Flash (DN 40)

Sanitary seal multi-adapter (C10SA)


Other details of Fluidless EJAC60E

  • Resistant to excessive pressure
    • The wetted sensor part is a reinforced type SUS 329 J 14 L.
    • Metal diaphragm prevents brittle fracture
  • Resistant to condensation
    • High moisture resistance with special moisture-proof film + coating
    • Outperforms other manufacturers more than 20 times in dew condensation tests
  • Steam resistant
    • Sensor is formed by sputtering method, resulting in no aging deterioration of the joint.
    • Electrode is fused with metal to achieve the durability for 200,000 steam cycles.
Structure of the fluidless transmitter EJAC60E


Contact Us 


  • Food & Beverage

    In the food manufacturing industry, in addition to the conventional challenges of achieving both "ensuring food security and safety" and "cost reduction," manufacturers are also working to cope with infectious diseases and labor saving.
    YOKOGAWA supports manufacturers to create comfortable workplaces by working closely, coping with challenges together, and proposing ideal factories suitable for operations.

    See More

Related Products & Solutions