Measurement data
The MV100/MV200 can save data in two formats (event data and display data).

Event data for detailed analysis

The display data format is used to save data displayed as waveforms. Each time the waveform display is updated, two data values (maximum and minimum values) measured since the previous update are saved.

Display data for extended-period trend recording

The display data format is used to save data displayed as waveforms. Each time the waveform display is updated, two data values (maximum and minimum values) measured since the previous update are saved.

The two data formats can be used in combinations such as the following:

• Display data only
• Event data only
• Display data and event data in combination

Display data, event data, and a trigger function can be used in combination. With this approach, display data with a slow sample rate can be used for continuous extended-period recording, and event data with a faster sample rate can be used to record short-term details.

In addition to measurement data, the MV100/MV200 can also save the following types of data:

• Manual sampling data: Instantaneous values (the 50 most recent measurements) occurring at each contact input or key input are saved in ASCII format.
• Time-series (TLOG) calculation data: Maximum value, minimum value, integrated (totalized) value, etc. during fixed interval (with calculation option)
• Report data: Hourly reports, daily reports, weekly reports, monthly reports (with calculation option)
• Settings data: Settings for set mode and setup mode