Boiler Leak Detection and Ion Exchange Resin Monitoring at Power Station

下载 (237 KB)

Introduction

Seawater leak detection is one of the post-condensation water quality management processes that are performed for power station boilers and similar facilities. Damage to the ion exchange resin, which deionizes the supplied water, is also monitored during this process, and both of these applications are executed by a conductivity analyzer.

Expected Benefits

  • Detects seawater leakage and ion exchange resin damage
  • Reduces operating cost

Process Overview

Boiler Water Quality Management Process

Boiler Water Quality Management Process

The above illustration shows where analyzers are used in the boiler water quality management process.

In the measurement point iab-app-x-en.gif shown in the figure, two different signal ranges are needed for deionized water management and seawater leak detection. The SC450 can simultaneously generate output signals for two different ranges, meaning that a single unit can perform deionized water management concurrently with seawater leak detection.

Other applications for this conductivity analyzer include the management of deionized boiler water.

Solution Details

iab-app-ionexchange-002r2.gif

Measurement system 4-wire conductivity system
Converter SC450G-A-☐
Sensor SC4A(J)-S-AD-09-002-☐☐-T1/PS
General Specifications
SC450G 4-wire Conductivity Converter
Measuring range (at process temperature; C: cell constant)
[Conductivity] Minimum: 0 µ/cm
Maximum: 200 mS/cm x C (overrange: 1999 mS/cm)
[Resistivity] Minimum: 0.005 kΩ/C
Maximum: 999 MΩ·cm
[Temperature] Pt1000: -20 to +250°C
Output setting range
[Conductivity] Minimum: 0.010 µS/cm
Maximum: 1999 mS/cm
[Resistivity] Minimum: 0.001 kΩ·cm
Maximum: 999 MΩ·cm
[Temperature] Min. span: 25°C; Max. span: 250°C
Output signal: two outputs of 4-20 mA DC
Construction: for outdoor installation, IP66, NEMA 4X waterproof
Ambient operating temperature: -20 to +55°C
Power supply voltage: 90 to 264 V AC, 50/60 Hz
Power consumption: 15 VA maximum
SC4A(J) Conductivity Sensor
Electrode system: two-electrode system
Cell constant: 0.02 cm-1
Measuring range: 0 – 0.5 µS/cm to 0 – 200 µS/cm
Temperature range: 0 - 110°C
Wetted material: SUS316L, PEEK (polyether ether ketone) /PS Adapter (option code of SC4A(J))
Material: SUS316L
Operating pressure: 1 MPa maximum (depends on the SC4A(J) Sensor)

行业

相关产品&解决方案

FLXA202/21两线制变送器/分析仪

FLEXA系列分析仪用于工业设施中的连续在线测量。它是灵活的两线制分析仪,可选择单传感器或双传感器测量。

SC42/SC4A(J)接触式电导率传感器

测量水溶液的特定电导率对于确定水中的杂质越来越重要。横河电机设计了一系列精密传感器和仪器,即使在极端条件下也能应对这些测量。

×

Have Questions?

Contact a Yokogawa Expert to learn how we can help you solve your challenges.

置顶
WeChat QR Code
横河电机(中国)有限公司
WeChat Recruiting QR Code
横河电机中国招聘